Posted on Feb 14, 2014 7:45 AM, The Corsair Support Forums - Cooling | www.asktheramguy.com
First off this RAM GUY posting beta software and firmware and then closing the thread so no one can give coherent feed back is borderline ridiculous.
As the title says I installed this link software and first time it ran it asked me to update my firmware 1.07 (from 1.05). I had read the post from the 'RAM GUY' that indicated only update if need so but since it popped up in a user friendly window in the software I figured it is now main stream.
After upgrading I lost control on the h100i led settling. Read if you slide all slider to top and then bottom you get control again. This worked however after each cold boot I was left with the bright obnoxious blue/white led again until I slide all sliders up and down again and again and again after each reboot. Reinstalled 1.05 and led sets are remember again.
Why close the threads so not one can give feed back RAM GUY?
Why have a beta software have a friendly pop up to upgrade firmware when you state
If your cooler is working properly DO NOT do this update it is released to help solve a specific issue and not everyone will have to do this update.
and give a whole procedure about letting it run for 1 minute etc.
Still do not know if this software followed the reset and wait procedure or the firmware does not work on my unit. Either way I am back to 1.05 and thing are running as expected.
Quit closing your threads and let people give feed back in the correct posts instead of starting a new thread for a CLOSED STICKY